Used: Thermal treatment, processing, mixing and storage of various materials in the food and chemical industry
Technical Specifications: Specifications of the device are made according to the type of material contained in the inner wall tank made of stainless steel 304 or 316 double polyester. The pressure jacket is fitted with pressure-resistant jacket tensile with the capacity of pressure 4 times on the wall and floor of the tank. Thermal oven with steam, hot water, cold pressurized water, indirect heat transfer through the material in the reservoir. To prevent heat loss, the thermal jacket is sealed with 50 mm of isolation and a layer of stainless steel 304 double sheet metal, while protecting the insulation, creates a beautiful look for the reservoir. All internal welds are fully covered in order to prevent contamination and also jarring due to have a good appearance. Depending on the type and viscosity of the material inside the reservoir and the type of operation that should be carried out on these materials, different types of mixer and different powers and type of blade are appropriately designed and installed on the processing tanks. In all cases, the blade is designed in such a way that, in addition to being able to be detached from the shaft, it is free from any area for the accumulation of contamination. All mixers are fitted with an electromotor and a gearbox to connect to the tank to prevent any vibration and noise from the interface system. Equipped with custom doors, customizable stainless steel bases, lights, hubs or washing turbines, ladders, hand wheels, electrodes, ventilators, anti-foam inputs and fittings. Depending on the type of function designed for the processing vessels with a bottom of the funnel or flat floor, as well as a funnel or a simple ceiling with half door design.